Programming note: The first user added will be the Master User of the lock and will be needed to add/remove additional users.
Wake up your BenjiLock by touching the screen.
Insert the key and turn counterclockwise until the BLUE LED fingerprint sensor light appears solid.
Touch the screen again (any finger) then press the button on the bottom once (Two-step verification)
Place your preferred finger on the sensor 5 times, holding until the blue LED turns off. (This will be the Master User)
The LED on top will flash BLUE, letting you know your fingerprint was stored.
Remove the key, and your lock is programmed.
Troubleshooting: If the LED at the top of the lock flashes RED, this means your fingerprint has not been recorded. If this happens, simply continue following the steps for programming.
(You have successfully programmed the "Master User")