Add additional users to your BenjiLock
- Wake up the lock: Touch the fingerprint sensor briefly and the BLUE LED screen light will flash.
- Insert the key and turn counterclockwise until the BLUE LED screen light appears solid.
- You now press the silver button at the bottom of the lock 2-10 times to correspond to the user you are programming.
- Wait two seconds until the LED light flashes BLUE at the top of the lock.
- The LED at the top of the lock will flash once for user 1.
- Place your finger on the fingerprint sensor until the BLUE LED at the top of the lock turns on and remove your finger after it turns off.
- Repeat the previous step four more times with the same finger for a total of 5 times. On the fifth time, remove your finger once the BLUE LED at the top of the lock appears solid. The light will then blink multiple times indicating successful programming.
- The BLUE LED in step 4 will flash and correspond to the number of times you press the silver button (1-10).
- Troubleshooting: If the LED at the top of the lock flashes RED, this means your fingerprint has not been recorded.
- Go back to step 1 and start over.