Follow the steps below to change the Numerical Passcode which is used to supplement fingerprints, if desired. Only one passcode can be stored, entering a new passcode overwrites an existing passcode.
(Step 1) With the shackle closed, place and hold the "Master User" finger against the sensor. The six LEDs around the fingerprint sensor will illuminate solid blue and the shackle will open. After four seconds, the six LEDs around the fingerprint sensor will illuminate blue three at a time in a rotating “wheel” pattern. On the back of the lock, the Blue and Red LEDs will flash simultaneously.
(Step 2) Within four seconds, begin entering a passcode of 3-8 digits using the ➊, ➋ & ➌ buttons on the back of the lock. (For example, ➊-➋-➌-➊) The Blue LED above the numbers will turn solid as each button is pressed. There is no “Enter” button; the passcode is set after two seconds of inactivity.
To ensure programming was successful:
(Step 1) Close the shackle by pressing it into the body of the lock.
(Step2) Wake the lock by touching the fingerprint sensor briefly with any finger that has not already been programmed.
(Step 3) Within four seconds, enter the passcode – the shackle should open. NOTE: The lock must be awake to use the passcode.
(If programming was not successful (for example, if only a 2-digit code was entered), the Red LED above the numbers will illuminate. If this happens return to Step 1 and restart the process.)