Follow the steps below to Program an Additional User/Fingerprint. Up to four additional fingerprints can be programed.
(Step 1) With the shackle closed, press and hold the Master User Fingerprint against the fingerprint sensor. (The LEDs around the fingerprint sensor will illuminate blue and the shackle will open. Don't remove your finger until the six LEDs around the fingerprint sensor illuminate blue three at a time in a rotating “wheel” pattern.)
(Step 2) Within four seconds, place the finger you want to program against the fingerprint sensor; one of the LEDs around the fingerprint sensor will illuminate blue and remain lit. Lift and replace the finger until all six of the blue LEDs are illuminated (indicating six successful fingerprint scans). If programming is successful, the six LEDs will remain illuminated blue for about three seconds and then flash simultaneously three times.
(Step 3) Remove your finger and close the shackle
(If programming was not successful, the LEDs around the fingerprint senor will illuminate red. If this happens return to Step 1 and restart the process until programming is successful.)
To ensure the programming was successful:
(Step 1) Close the lock by pressing the shackle into the body of the lock.
(Step 2) Touch the fingerprint sensor with your newly programmed finger and let it remain in place until the LEDs illuminate blue and the shackle is released.
(If the programming was not successful or an unregistered fingerprint is used, the LEDs around the fingerprint sensor will illuminate red.)